IAI America PCON-CA - Manual (Page 249)

Chapter 9
Appendix
POWER CON
PCON-CA/CFA
241
[8] Position 1 Operation Circuit
The main circuit is designed to process and manage signals “start” o “moving” o “positioning
complete” to move the actuator to position No.1.
STA R TL PEND
RC Start
Display
AUX7
Position 1
Positioning
Start Pulse
AUX10
Position 1
Positioning
Start Check
Point
Positioning
Completion
AUX17
Position 3
Positioning
Complete
AUX6
Completed
Position 3
078
OUT1
IN13 OUT1 AUX9
a083 a087 b132
a135 b144 b151
a162
Auxiliary Position 1
Positioning Start
AUX9
Auxiliary Position 1
Positioning Start
STA R TL PEND
RC Start
Display
AUX9 AUX 1 1
Position 1
Positioning
Complete
Point
Positioning
Completion
087
093
AUX10
AUX10
a084 a089 b093
Position 1
Positioning Start Check
Auxiliary
Position 1
Positioning
Start
Position 1 Positioning
Start Check
STA R TL
RC Start
Display
AUX10 AUX4 AUX12 AUX 1 1
AUX11
b 090 a095 b099
Position 1
Positioning Complete
Auxiliary
Position 2
Positioning
Start
Position 1
Positioning Complete
Position 1
Positioning
Start Check
Completed
Position 1
IN13 OUT1
OUT1
If 1 is not pulsed, 3 is reset
with 4 turned ON and 2 is
turned ON again.
Position 2 start signal
If movement is completed,
the moving circuit is turned OFF.
Turned OFF at start of next positioning
to position No.2.
Because any of start, moving or completion is set to
ON, it is possible to know the state in which the
actuator is stopped if it occurs.
If movement is started (PEND is
turned OFF), the start circuit is turned OFF.
Without home return, positioning to
position No.2 takes place after
home return
Moving
Complete
Startup
• Circuit 10 is designed to start positioning to position No.1 again after positioning to position No.3
is completed.
• If the “Operation” lamp goes off, the operation circuit is reset entirely. When the “Stop” button is
pushed, the actuator will stop at completion of the operation being executed. At emergency
stop, the actuator is stopped immediately (which is the function of PCON).