Bio-Rad ChromLab™ Software - Manual (Page 273)

Plumbing NGC Systems
Instrument Guide | 271
Plumbing the NGC Quest System
Table 20 lists the tasks for plumbing the NGC Quest™ system. The tasks are
explained in detail in the sections that follow.
Note: Ensure that you complete the plumbing tasks in the section Plumbing All
NGC Systems on page 265 before continuing.
The figure on page 272 shows the Point-to-Plumb™ connections for the
NGC Quest system.
Table 20. Plumbing tasks for the NGC Quest system
Tasks
1. Inlet tubing to the system pump A inlet manifold
2. Inlet tubing to the system pump B inlet manifold
3. Tube #4 from the 40 psi backpressure regulator to the Common inlet port
on the BioFrac™ fraction collector diverter valve