Bio-Rad ChromLab™ Software User Manual
Page 293
Advertising
Using the C-96 Autosampler with NGC Systems
Instrument Guide
| 291
8.
On the back of the autosampler:
a.
Insert the 15-pin cable into the left (P1 RELAYS OUTPUTS) connector port
and tighten the thumbscrews.
b.
Insert the 9-pin cable into the right (P2 INPUTS) connector port and tighten
the thumbscrews.
9.
On the back of the SIM:
a.
Insert the P1 RELAYS OUTPUTS cable into the DIGITAL IN port.
b.
Insert the P2 INPUTS cable into the DIGITAL OUT port.
Advertising
This manual is related to the following products: