H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 24)

8
Feature matrix for the WX3024E
NOTE:
•
The access controller engine and switching engine of the WX3024E adopt the OAP architecture. The switching engine is integrated on the access controller
engine and adopts OAP architecture. You actually log in to the access controller engine when you log in to the switch by default. The GE 1/0/1 and GE
1/0/2 interfaces of the access controller engine form a logical interface BAGG1, and the GE1/0/29 and GE1/0/30 interfaces of the switching engine
form a logical interface BAGG1. The two BAGG1 interfaces exchange data, status, and control information. Do not configure services such as QoS rate
limiting and 802.1X authentication on these internal interfaces.
• For configuration information about the switching engine of the WX3024E, see the H3C WX3024E Wireless Switch Switching Engine Configuration Guide
and H3C WX3024E Wireless Switch Switching Engine Command Reference.
Table 4 Feature matrix for the WX3024E
Module Feature WX3024E
Device
License management
Supports 24 concurrent APs by default, and can be extended to support 60
concurrent APs.
File management Flash supported
Port mirroring No
Loopback test Internal loopback testing supported on GE interfaces only
Network IGMP Snooping The maximum number of multicast groups ranges from 1 to 64 and defaults to 64.
AP
AP group (Licenses must be fully configured to reach the
maximum number of group IDs)
The number of group IDs ranges from 1 to 60.
Wireless Service Access service The maximum number of associated users per SSID is 124, and defaults to 64.
Advanced settings
AC backup No
Fast backup (Hello interval) No
1+1 AC backup No
High availability Stateful failover No