Wireless service configuration example, Network requirements, Configuring the ac – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 269
253
Field Description
GTK Rekey
GTK rekey configured.
GTK Rekey Method
GTK rekey method configured, which can be:
•
Time-based, which displays the GTK rekey time in seconds.
•
Packet-based, which displays the number of packets.
GTK Rekey Time
Time for GTK rekey in seconds.
Bridge Mode
Forwarding mode, which can be:
•
Local Forwarding—Use the local forwarding mode.
•
Remote Forwarding—Use the remote forwarding mode, that is,
uses the AC to forward data.
Service Template Status
Service template status, which can be:
•
Enable—Indicates that the wireless service is enabled.
•
Disable—Indicates that the wireless service is disabled.
Maximum clients per BSS
Maximum number of associated clients per BSS.
Wireless service configuration example
Network requirements
As shown in
, an AP is required to enable employees to access the internal resources at any
time. More specifically:
•
An AC and the AP (serial ID 210235A29G007C000020) is connected through a Layer 2 switch.
•
The AP provides clear type wireless access service with SSID service1.
•
802.11n (2.4GHz) radio mode is adopted.
Figure 238 Network diagram
Configuring the AC
1.
Create an AP:
a.
Select AP > AP Setup from the navigation tree.
b.
Click Add.
c.
On the page that appears, set the AP name to ap, select the AP model WA2620-AGN, select
the serial ID manual, and enter the serial ID of the AP.
d.
Click Apply.