H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 349)

333
On Radio 1 of the MPP, configure Radio 1 of MP 1 as the peer MAC address. Similarly,
configure Radio 1 of the MPP as the peer MAC address on MP 1. Perform the same operation
for Radio 2 of MP 1 and Radio 1 of MP 2.
2. Configure the access service:
As the multi-beam antenna, Radio 3 provides the wireless access service. For more information,
see "
Wireless service configuration example ." You can strictly follow the configuration example to
configure the access service.
Configuration procedure
The mesh configuration here is similar to a common wireless mesh configuration. For more information,
see " Configuring the AC ."
Mesh DFS configuration example
Network requirements
• As shown in Figure 363 , establish an 802.11a mesh link between the MAP and MPP. The working
channel is automatically selected.
• Enable one-time DFS. After that, the AC performs DFS for the radios when certain trigger conditions
are met on the channel.
Figure 363 Network diagram
Configuration considerations
The mesh configuration in this example is similar to a common wireless mesh configuration. Note the
following guidelines:
• Configure the working channel mode of the radios that provide mesh services as auto.
• Do not configure any wireless service on radios that provide mesh services.
Configuration procedure
The mesh configuration is the same as the normal WLAN mesh configuration. For configuration
procedures, see " Normal WLAN mesh configuration example ." Perform the following operations after
completing mesh configuration:
1. (Optional) Set a calibration interval:
a. Select Radio > Calibration from the navigation tree.
b. Click the Parameters tab.
c. On the page that appears, enter the calibration interval 3 and click OK.