H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 347)

331
Set the value of maximum links that an MP can form in a mesh network (the default value is 2.).
For more information, see " Configuring a mesh policy ."
Figure 359 Network diagram
Configuring the AC
Subway mesh configuration differs from normal WLAN mesh configuration in the mesh policy
configuration of rail APs and train APs. Other configurations are the same. For more information, see
" Configuring the AC ."
Mesh point-to-multipoint configuration example
Network requirements
AP 1 operates as an MPP to establish a mesh link with AP 2, AP 3, AP 4, and AP 5 respectively.
The mesh configuration is the same as the normal WLAN mesh configuration.
Figure 360 Network diagram
Configuration considerations
• Configure a peer MAC address for each radio interface. Configure the MAC addresses of AP 2
through AP 5 on AP 1, and configure the MAC address of AP 1 on AP 2 through AP 5.
AP 1 AC
AP 2
AP 3
AP 4
AP 5