H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 256)

240
Item Description
Multicast Trigger
• Enable—Enable the multicast trigger function of 802.1X to send
multicast trigger messages to the clients periodically for
initiating authentication. By default, the multicast trigger
function is enabled.
• Disable—Disable the 802.1X multicast trigger function.
IMPORTANT:
For a WLAN, the clients can actively initiate authentication, or the AP
can discover users and trigger authentication. Therefore, the ports
do not need to send 802.1X multicast trigger messages periodically
for initiating authentication. You are recommended to disable the
multicast trigger function in a WLAN because the multicast trigger
messages consume bandwidth.
MAC Authentication Select MAC Authentication.
Domain
Select an existing domain from the list.
The default domain is system. To create a domain, select
Authentication > AAA from the navigation tree, click the Domain
Setup tab, and enter a new domain name in the Domain Name
field.
• The selected domain name applies to only the current wireless
service, and all clients accessing the wireless service use this
domain for authentication, authorization, and accounting.
• Do not delete a domain name in use. Otherwise, the clients that
access the wireless service will be logged out.
Configuring crypto type wireless service
Configuring basic settings for a crypto type wireless service
1. Select Wireless Service > Access Service from the navigation tree.
2. Click the icon corresponding to the target crypto type wireless service to enter the page for
configuring wireless service.
Figure 227 Crypto type wireless service
3. Configure basic settings for the crypto type wireless service as described in Table 89 .
4. Click Apply.