H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 69)

53
Figure 36 Displaying AP detailed information
Table 22 Field description
Field Description
APID Access point identifier.
AP System Name Access point name.
Map Configuration Configuration file mapped to the AP.
State
Current state of the AP:
• ImageDownload—The AP is downloading the version. If the
ImageDownload state persists, check the following: 1) The version of the
fit AP saved on the AC matches with the version that the AC requires; 2)
The space of the flash is enough.
• Idle—The AP is idle. If the Idle state persists, check the following: 1) If the
fields of Latest IP Address and Tunnel Down Reason are displayed as
-NA-, it indicates that the AP has never connected to the AC successfully.
You need to check the network cable, power supply of the fit AP, and the
AP serial number if the serial number was manually input. 2) If the fields
of Latest IP Address and Tunnel Down Reason are displayed as other
contents, it indicates that the AP has connected to the AC successfully.
See the output of the Tunnel Down Reason field for the detailed reason.
• Run—The AP is operating. It indicates that the AP has connected to the
AC successfully.
• Config—The AC is delivering configuration file to the fit AP, and the fit AP
is collecting radio information through the radio interface and reporting
to the AC. This state is an instantaneous state.
Up Time(hh:mm:ss)
Time duration for which the AP has been connected to the AC. NA indicates
AP is not connected to the AC.
Model AP model name.