H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 519)

503
Item Description
Action
Select the action to be performed for IPv4 packets matching the rule.
• Permit—Allows matched packets to pass.
• Deny—Drops matched packets.
MAC
Address
Filter
Source MAC
Address
Select the Source MAC Address option and enter a source MAC address
and wildcard.
Source Mask
Destination MAC
Address
Select the Destination MAC Address option and enter a destination MAC
address and wildcard.
Destination Mask
COS(802.1p priority) Specify the 802.1p priority for the rule.
Type Filter
LSAP Type
Select the LSAP Type option and specify the DSAP and SSAP fields in the LLC
encapsulation by configuring the following items:
• LSAP Type—Indicates the frame encapsulation format.
• LSAP Mask—Indicates the LSAP wildcard.
TIP:
You can select only one of the LSAP Type option and the Protocol Type option.
LSAP Mask
Protocol Type
Select the Protocol Type option and specify the link layer protocol type by
configuring the following items:
• Protocol Type—Indicates the frame type. It corresponds to the type-code
field of Ethernet_II and Ethernet_SNAP frames.
• Protocol Mask—Indicates the wildcard.
TIP:
You can select only one of the LSAP Type option and the Protocol Type option.
Protocol Mask
Time Range Select the time range during which the rule takes effect.
Adding an IPv6 ACL
1. Select QoS > ACL IPv6 from the navigation tree.
2. Click the Add tab to enter the IPv6 ACL adding page, as shown in Figure 537 .