H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 343)

327
Configuring the AC
1. Create an MAP and MPP:
a. Select AP> AP Setup from the navigation tree.
b. Click Add.
c. On the page that appears, set the AP name to map, select the AP model WA2620-AGN, select
the serial ID manual, enter the AP serial ID, and click Apply.
Figure 351 AP setup
d. Configure MPP by following the same steps.
2. Create a mesh service:
a. Select Wireless Service > Mesh Service from the navigation tree.
b. Click the Mesh Service tab.
c. Click Add.
d. On the page that appears, set the mesh service name to outdoor and click Apply.
After completing mesh service configuration, you enter the page shown in
Figure 353 .
Figure 352 Creating a mesh service
Figure 353 Configuring a pre-shared key
e. Select Pass Phrase, and set the pre-shared key to 12345678.
f. Click Apply.