H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 348)

332
• Set the value of maximum links that an MP can form in a mesh network (The default value is 2. It
should be set to 4 in this example.). For more information, see " Configuring a mesh policy ."
Configuring the AC
Mesh configuration is the same as normal WLAN mesh configuration. For more information, see
" Configuring the AC ."
Tri-radio mesh configuration example
Network requirements
As shown in Figure 361 , set up mesh links between MPs and the MPP, and use radio resources to make
Radio 1 of MPP, Radio 1 and Radio 2 of MP, and Radio 1 of an MP 2 join the same mesh and use Radio
3 as the multi-beam antenna, which provides the wireless access service.
Figure 361 Network diagram
Configuration considerations
1. Configure the mesh service:
The mesh configuration here is similar to a common wireless mesh configuration. Pay attention to
the following points:
Radios joining the same mesh must use the same mesh service. Thus, bind Radio 1 of MPP,
Radio 1 and Radio 2 of MP 1, and Radio 1 of MP 2 to the same mesh service.
Figure 362 Binding radios to the mesh service