H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 555)

539
By default, wireless QoS is enabled.
NOTE:
The WMM protocol is the foundation of the 802.11n protocol. When the radio works in 802.11n (5 GHz)
or 802.11n (2.4 GHz) radio mode, you must enable WMM. Otherwise, the associated 802.11n clients
may fail to communicate.
Setting the SVP service
NOTE:
SVP mapping is applicable only to non-WMM clients.
1. Select QoS > Wireless QoS from the navigation tree.
By default, the Wireless QoS tab is displayed, as shown in
Figure 566 .
Figure 566 Mapping SVP service to an access category
2. Click the icon in the Operation column for the desired AP to enter the page for mapping SVP
service to an access category, as shown in Figure 567 .
Figure 567 Mapping SVP service to an access category
3. Configure SVP mapping, as described in Table 180 .
4. Click Apply.
Table 180 Configuration items
Item Description
AP Name Displays the selected AP.