Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) User Manual
Page 340
Advertising
318
Fabric OS Message Reference
53-1003140-01
EM-2003
5
•
Execute the diagPost command to make sure that Power-On Self-Test (POST) is enabled; then
power cycle the blade by using the slotPowerOff and slotPowerOn commands or have the
blade's ejector switch cycled to run POST and verify that the blade does not have any hardware
problems.
•
On bladed systems, replace the specified FRU; otherwise, replace the switch.
Advertising