Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 788)

766 Fabric OS Message Reference
53-1003140-01
SEC-1072
5
SEC-1072
Message
<Policy type> Policy List is Empty.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates the specific policy type is empty. The security database is corrupted for unknown reasons.
Recommended
Action
Execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the
supportSave command and contact your switch service provider.
SEC-1073
Message
No FCS policy in list.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates the specific policy type is empty. The security database is corrupted for unknown reasons.
Recommended
Action
Execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the
supportSave command and contact your switch service provider.
SEC-1074
Message
Cannot execute the command on this switch. Please check the secure mode and FCS
status.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates a security command was run on a switch that is not allowed to run it either because it is in
non-secure mode or because it does not have the required fabric configuration server (FCS) privilege.
Recommended
Action
If a security operation that is not allowed in non-secure mode is attempted, do not perform the operation
in non-secure mode. In secure mode, run the command from a switch that has the required privilege; that
is, either a backup FCS or primary FCS.