Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 381)

Fabric OS Message Reference 359
53-1003140-01
FABS-1010
5
FABS-1010
Message
<Function name>: Wrong media_event <Event number>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the Fabric OS detected an unknown event type. This is usually an internal Fabric OS
problem or file corruption.
Recommended
Action
Reboot or power cycle the switch.
If the message persists, run the firmwareDownload command to update the firmware.
FABS-1011
Message
<Method name>[<Method tag number>]:Invalid input state 0x<Input state code>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that an unrecognized state code was used in an internal Fabric OS message for a
field-replaceable unit (FRU).
Recommended
Action
Reboot or power cycle the CP or system.
If the message persists, run the firmwareDownload command to update the firmware.
FABS-1013
Message
<Method name>[<Method tag number>]:Unknown blade type 0x<Blade type>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates an unrecognized type of blade has been discovered in the system.
This may be caused by an incorrect field-replaceable unit (FRU) header, inability to read the FRU
header, or the blade may not be supported by this platform or Fabric OS version.
Recommended
Action
Verify that the blade is valid for use in this system and this version of Fabric OS.
Reseat the blade.
If this is a valid blade and reseating does not solve the problem, replace the blade.