Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 479)

Fabric OS Message Reference 457
53-1003140-01
FICU-1007
5
Recommended
Action
Check if the FICON channel corresponding to the PID in the message is functioning correctly.
FICU-1007
Message
<function name>: Failed to allocate memory while performing <message>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that memory resources are low. This may be a transient problem.
Recommended
Action
Check the memory usage on the switch using the memShow command.
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
FICU-1008
Message
FMS mode has been enabled. Port(s):<port number(s)> have been disabled due to port
address conflict.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the specified ports were disabled when the FICON Management Server (FMS) mode was
enabled. This is due to a port address conflict or the port address being reserved for the CUP
management port.
Recommended
Action
No action is required.
FICU-1009
Message
FMS Mode enable failed due to insufficient frame filtering resources on some
ports.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the frame filtering resources required to enable FICON Management Server mode
(fmsMode) were not available on some of the ports.
Recommended
Action
Execute the haFailover command on the switch if it has redundant control processors (CPs) or reboot
the switch.