Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 430)

408 Fabric OS Message Reference
53-1003140-01
FCR-1097
5
FCR-1097
Message
Failed to get <data type> for <message phase> message: port <port number>, retval
<error code>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the authentication process failed to get a particular authentication value at certain phase.
Data type is the payload or structure that failed to get memory.
Recommended
Action
Usually this problem is transient. The authentication may fail.
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers;
then run the supportSave command and contact your switch service provider.
FCR-1098
Message
Invalid message code for <message phase> message: port <port number>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates the receiving payload does not have valid message code for a particular authentication phase.
Recommended
Action
Usually this problem is transient. The authentication may fail.
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers;
then run the supportSave command and contact your switch service provider.
FCR-1099
Message
HA sync lost as remote CP does not support Inter Chassis Link EX_Ports.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the remote control processor (CP) has older firmware that does not support inter-chassis
link (ICL) EX_Ports. This is causing loss of the high availability (HA) synchronization.
Recommended
Action
Disable EX_Ports on ICL links or upgrade the firmware on remote CP to v7.2.0 or later.