Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 606)

584 Fabric OS Message Reference
53-1003140-01
HAM-1001
5
HAM Messages
HAM-1001
Message
Standby CP is not healthy, device <device name> status BAD, Severity = <severity
level>.
Message Type
FFDC | LOG
Severity
CRITICAL
Probable Cause
Indicates that a standby control processor (CP) device error is reported by the high availability manager
(HAM) health monitor, with the specified device and severity level. The severity level can be critical,
major, or minor.
The active CP will continue to function normally. Because the standby CP is not healthy, non-disruptive
failover is not possible.
Recommended
Action
Restart the standby CP blade by ejecting the card and reseating it. If the problem persists, replace the
standby CP.
HAM-1002
Message
Standby CP is healthy.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that all standby control processor (CP) devices monitored by the high availability manager
(HAM) health monitor reported no error.
Recommended
Action
No action is required.
HAM-1004
Message
Processor rebooted - <Reboot Reason>.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the switch has been restarted because of a user action or an error. The switch restart can
be initiated by the firmwareDownload, fastBoot, haFailover, and reboot commands. Some examples
of errors that may initiate this message are hardware errors, software errors, compact flash errors, or
memory errors. The Reboot Reason variable can be one of the following:
• Hafailover
• Reset