Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 469)

Fabric OS Message Reference 447
53-1003140-01
FICN-1109
5
FICN-1109
Message
DevPrintEgr:FICON Selective Reset:Path=0x<VEPortNumber HostDomain HostPort
DeviceDomain><DevicePort LPAR CUADDR DeviceAddr> State=0x<the current state of
the device that received the selective reset> statArray=0x<the last 4 status
values received from the device> cmdArray=0x<the last 4 commands that were issued
to the device> tflags=0x<the current emulation tera control flags for the device>
sflags=0x<the current emulation status control flags for the device>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates the FICON channel issued a Selective Reset for a device that was active in emulation.
Recommended
Action
If there was an unexpected job failure associated with this event, contact your vendor's customer support
for assistance.
FICN-1110
Message
DevPrintEgr:FICON Selective Reset:Path=0x<VEPortNumber HostDomain HostPort
DeviceDomain><DevicePort LPAR CUADDR DeviceAddr> Elapsed Time=<the current SIO
time in seconds for the device>.<the current SIO time in milliseconds for the
device> seconds.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates the FICON channel issued a Selective Reset sequence for a device.
Recommended
Action
If there was an unexpected job failure associated with this event, contact your vendor's customer support
for assistance.
FICN-1111
Message
DevPrintEgr:FICON Purge received Path=0x<VEPortNumber HostDomain HostPort
DeviceDomain><DevicePort LPAR CUADDR DeviceAddr>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates the FICON channel issued a Purge Path command sequence for a device.
Recommended
Action
If there was an unexpected job failure or I/O error associated with this event, contact your vendor's
customer support for assistance.