Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 409)

Fabric OS Message Reference 387
53-1003140-01
FCR-1024
5
FCR-1024
Message
Local LSAN zone <zone name> device entries for edge LSAN exhausted.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the number of devices in a logical storage area network (LSAN) defined in the edge fabric
is greater than allowed by the local LSAN zone database limitations.
Recommended
Action
Remove excess device entries from this LSAN zone until the number of devices is within the range of the
local LSAN zone database limitations.
FCR-1025
Message
Local phantom node WWN entries exhausted.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the number of node World Wide Names (WWNs) detected to be in use exceeds the local
node WWN resources.
Recommended
Action
Reduce the number of node WWNs required by limiting the remote edge fabric connectivity (which limits
the number of translate domains).
FCR-1026
Message
In slot <slot number>, Node WWN roll over.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the node World Wide Name (WWN) pool has rolled over in the specified slot, and WWN
entries not detected to be in use are reused as needed.
Recommended
Action
It is unlikely that WWN conflicts will occur as a result of pool rollover unless the switch is deployed in a
very large MetaSAN environment with a large number of logical storage area network (LSAN) devices
and fabrics, or there are highly dynamic changes to EX_Port connectivity. WWN conflicts might cause
unpredictable behavior in management applications. To avoid WWN conflicts, all EX_Ports attached to
fabrics with highly dynamic changes to EX_Port connectivity should be disabled and then re-enabled.