Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 911)

Fabric OS Message Reference 889
53-1003140-01
SULB-1001
5
SULB Messages
SULB-1001
Message
Firmwaredownload command has started. (From v<current_version> To
v<new_version>).
Message Type
AUDIT | LOG
Class
FIRMWARE
Severity
WARNING
Probable Cause
Indicates that the firmwareDownload command has been entered. This process should take
approximately 17 minutes. The process is set to time out after 30 minutes.
Recommended
Action
Do not fail over or power down the system during firmware upgrade. Allow the firmwareDownload
command to continue without disruption. No action is required.
Run the firmwareDownloadStatus command for more information.
SULB-1002
Message
Firmwaredownload command has completed successfully.
Message Type
AUDIT | LOG
Class
FIRMWARE
Severity
INFO
Probable Cause
Indicates that the firmwareDownload command has completed successfully and switch firmware has
been updated.
Recommended
Action
No action is required. The firmwareDownload command has completed as expected.
Run the firmwareDownloadStatus command for more information. Run the firmwareShow command
to verify the firmware versions.
SULB-1003
Message
Firmwarecommit has started.
Message Type
AUDIT | LOG
Class
FIRMWARE
Severity
INFO
Probable Cause
Indicates that the firmwareCommit command has been entered.