Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 732)

710 Fabric OS Message Reference
53-1003140-01
PLAT-1003
5
PLAT-1003
Message
<Info message> Slot <Blade Slot number> C/BE: 0x<Captured Command/Byte-Enables
data> ADBUS: 0x<Captured AD bus data> misc_intr 0x<Bridge reset interrupts>.
Message Type
LOG | FFDC
Severity
CRITICAL
Probable Cause
Indicates that peripheral component interconnect (PCI) bus hang was detected.
Recommended
Action
Replace the field-replaceable unit (FRU).
PLAT-1004
Message
Switch has older FPGA rev 0x<FPGA version already installed in HW>. Upgrade to
newer rev 0x<FPGA version which Fabric OS carries> using the fpga_update command.
Message Type
LOG | FFDC
Severity
CRITICAL
Probable Cause
Indicates that Fabric OS has older field-programmable gate array (FPGA) version. This message is
applicable only to Brocade 5470.
Recommended
Action
Upgrade FPGA to new version.
PLAT-1005
Message
Incompatible midplane detected. All internal ports will be disabled.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the chassis has the revision 1.0 midplane.
This message occurs only on the Brocade M6505.
Recommended
Action
Replace the midplane with a revision 1.1 midplane.