Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 776)

754 Fabric OS Message Reference
53-1003140-01
SEC-1024
5
SEC-1024
Message
The <DB name> security database is too large to fit in flash.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates the size of the security database is too large for the flash memory. The size of the security
database increases with the number of entries in each policy.
Recommended
Action
Reduce the size of the security database by reducing the number of entries within each policy.
SEC-1025
Message
Invalid IP address (<IP address>) detected.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates a corruption occurred during the distribution of the security database. This can occur only when
the primary fabric configuration server (FCS) distributes the security database to the other switches in
the fabric, and then local validation finds the error in the security database. This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database may not be correctly updated for that
specific switch.
SEC-1026
Message
Invalid format or character in switch member <switch member ID>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates a corruption occurred during the distribution of the security database. This can occur only when
the primary fabric configuration server (FCS) distributes the security database to the other switches in
the fabric, and then local validation finds the error in the security database. This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database may not be correctly updated for that
specific switch.