Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 791)

Fabric OS Message Reference 769
53-1003140-01
SEC-1081
5
SEC-1081
Message
Entered a name for a DCC policy ID that was not unique.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates the Device Connection Control (DCC) policy name given in the secPolicyCreate command
was the same as another DCC policy.
Recommended
Action
Make sure that the DCC policy name has a unique alphanumeric string, and run the secPolicyCreate
command again.
SEC-1082
Message
Failed to create <policy name> policy.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates the security policy was not created because of faulty input or low resources.
Recommended
Action
Use proper syntax when creating policies. If the security database is too large, you must delete other
members within the database before adding new members to a policy.
SEC-1083
Message
Name already exists.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates a corruption occurred during the distribution of the security database. This can only occur when
the primary fabric configuration server (FCS) distributes the security database to the other switches in
the fabric, and then local validation finds the error in the security database. This is a rare occurrence.
Recommended
Action
Run the fabricShow command to verify that the fabric is still consistent. All the switches should be in the
ready state. If a switch is in the error state, the database may not be correctly updated for that specific
switch.