Metrohm 796 Titroprocessor - Manual (Page 131)

7. Titration and measuring modes
796 Titroprocessor, Instructions for use 125 125
MP_List Measuring point list
Calc. Calculation report with formulas
RawData Raw data report for LIMS output
FormFeed Page feed at printer
FullStat Full statistics data report
ShrtStat Short statistics data report
+ Multiple curves of all determinations in the statistics
memory
For routine titrations a standard report with a volume
curve is recommended as this contains the most impor-
tant data for the determination; see example on page 127.
Specification
Measuring quantity on the Y-axis of a curve
Depending on curve type: Measured value | Volume
Temp.| dMV/dV | dMV/dt | dV/dt
MV,Temp. | MV,dMV/dV | all
If a curve report has been selected then a specification
for representation of the measuring quantity on the X-axis
can be entered. Different entries can be selected de-
pending on the type of curve.
M.value Measured value: pH, mV, µA, °C depending
on mode
Volume Added volume in mL
Temp. Temperature in °C
dMV/dV 1st derivative of titration curve according to
volume
dMV/dt 1st derivative of titration curve according
to time
dV/dt 1st derivative of volume according to time
MV,Temp Measured value and temperature, combined
MV,dMV/dV Measured value and 1st derivative
combined
all all representable quantities
The scaling of the Y-axis of a curve report in the definition
of the curve display under [* Param] [Curve dis-
play]- Division
. The use of a grid for the output of a
curve can also be switched on here.
For page-oriented printers the definition of a page feed
before each curve report is recommended, see FF below.
print
Print out the report
yes | no
A report will be printed out (with 'yes') on all the printers
defined in the configuration. These can be both the inter-
nal printer as well as an external printer connected to the
'Printer' socket or an RS 232 interface.