Metrohm 796 Titroprocessor - Manual (Page 190)

8.10 Sample changer commands
796 Titroprocessor, Instructions for use 184 184
8.10 Sample changer commands
ЪДДДДДДДДДДД¿
³Titration >³
³Changer >³
³CAL ЪДДДДДДД¿
³MEAS_* ³
CHANGER ³
³DOS ³SAMPLE ³
³STIR_I ³MOVE_S ³
³CASE ³MOVE_B ³
³COMM ³LIFT ³
³AUX ³PUMP ³
АДДДДДДДДДД³STIR_C ³
³RESET_C³
³(OMOVE ³
³)OMOVE ³
³(CMOVE ³
³)CMOVE ³
АДДДДДДДЩ
The versatile commands for controlling one (or two) 717 Sample
changer(s) allow the comprehensive automation of even complex working
procedures. With the sequences
(OMOVE…)OMOVE and
(CMOVE…)CMOVE sample series can be processed in a very individual
manner. Conditional processes can be realized with
(CASE…EXIT…)CASE structures.
The standard methods supplied on the flash card (SCsimple.mth) for sam-
ple changer control can be easily altered and adapted to meet different
requirements.
Stored sample changer methods can usually be easily transferred to other
796 Titroprocessors. However, care must be taken that the rack definitions
(including working and rotating lift positions, positions and names of the
special beakers, etc.) of the corresponding sample changer are carried out
correctly.
8.10.1 Sample changer commands
CHANGER
Basic sample changer settings
The CHANGER command sets the active (of two possi-
ble) 717 Sample changer and defines its basic settings.
The command can be programmed at any point of the
run so that it is possible to operate two different sample
changers within a single method. The EBus address
selector disk on the appropriate sample changer must
be set correctly: for the first changer to
1, for the second
changer to 2, see sample changer installation on page
25.
Command Parameters Parameters
ДДДДДДДДДДДДД ДДДДДДДДДДДДДДДДДДДДДДДД ДДДДДДДДДДДДДДДДДДДДДДДД
CHANGER Selection 1 Rack name
Lift rate 1 25 Lift rate 2 25
Shift rate 20 Beaker test mode single
Shift direction auto On beaker error MOVE_S
Selection
Address of the active sample changer
1 | 2
The changer address defines which changer is active
and for which sample changer the following basic set-
tings will apply.
Rack name
Name of the required rack
8 characters
This entry is optional. If a rack name has been entered
then the use of the described rack will be forced, i.e.