Metrohm 796 Titroprocessor - Manual (Page 80)

5.2 Method editor
796 Titroprocessor, Instructions for use 74 74
command will not be carried out until this time has elapsed and the
command involved has been carried out completely.
The functions and parameters of the individual commands are described in
detail in section
8. Command references (page 127ff).
A method is stored in the file dialog window (see page 72) with the [Save]
softkey. The method name, storage area and an optional method
commentary can be freely selected.
5.2.3 Softkeys and their functions
[Note]
edits the application note which appears on the main
page. A short description of the current method or of the
sample preparation method can be entered. In the
application note edit window. The [Delete line],
[Blank line]
[Copy line] [Paste line]
softkeys are available for comfortable text editing.
[File]
The basic file operations are available in the file dialog
window (see page 72).
The name of a file can be freely selected or chosen from
the selection list of the selected storage area by pressing
the space bar. If files are to be saved on a computer
system then file names should be selected which the file
system of the computer can read. Avoid special
characters. Mixed capitals and lower case letters are
accepted by the Titroprocessor 796; however, this may
cause problems with other file systems.
Each file can be provided with a comment of max. 50
characters which appears in the selection list of the file
dialog window and in the file manager.
The selection of the memory area can also be made via a
selection list. A file can be transmitted or received via an
RS232 interface. These special functions are described in
the file manager section.
[Determ.
In addition to or instead of the mode report of titrations
report]
or measurements a report of a complete determination
can be defined. This is particularly recommended when
several titration or measuring modes have been
programmed in a single method. Determination reports
form introductory and concluding report blocks as part of
the complete report. Between these the individual mode
reports (see [*Report] softkey below) are listed.
Detailed descriptions of the definition of determination
reports are given below.