10 curves and re-evaluation, 1 single curves – Metrohm 796 Titroprocessor User Manual
Page 225
10. Curves and re-evaluation
796 Titroprocessor, Instructions for use
219
219
10 Curves and re-evaluation
10.1 Single curves
By pressing the [Show curves] softkey on the main page titration curves
can be shown.
A curve can only be shown when a measuring point list containing at least
4 measuring points of a titration or a series of measurements is available.
The representation of the curve can easily be altered. In the same way as
the alterations on the results page, these alterations are only temporarily
valid, i.e. modifications to the presentation of the curve do not alter the
method.
It is possible to load the curve of a different determination directly from this
screen. Several curves of the same type can be overlapped for a direct
comparison.
Softkeys
[Select
file]
shows the selection list of the determinations contained in
the working memory. If several titrations or measurements
are contained in one determination then the required
curve can be selected from them. The selected curve is
shown according to its presentation parameters.