Metrohm 796 Titroprocessor - Manual (Page 196)

8.10 Sample changer commands
796 Titroprocessor, Instructions for use 190 190
Stirring rate
Stirrer speed
1…15 | off
The stirring speed of each individual stirrer can be varied
in 15 steps.
RESET_C
Initializing changer
After sample racks have been changed it is necessary to initialize the sam-
ple changer. This is done by rotating the sample turntable to the basic posi-
tion and reading off the magnetic code for identification of the rack. This is
normally carried out manually, but can also be programmed in a method
(preferably in the start sequence, see
OMOVE below).
Command Parameters Parameters
ДДДДДДДДДДДДД ДДДДДДДДДДДДДДДДДДДДДДДД ДДДДДДДДДДДДДДДДДДДДДДДД
RESET_C Selection 1
Selection
Changer address
1 | 2
Changer 1 or changer 2 are defined by the setting of the
EBus address selector disk on the sample changer, see
page 25.
(OMOVE
Start sequence for a series of samples
)OMOVE
When a series of samples is being processed it is often necessary to carry
out certain working steps a single time before the sample series itself. For
example, these could be rinsing procedures or conditioning steps for sen-
sors.
The definition of the necessary command sequence is made in an OMOVE
sequence ( OMOVE = Opening Moves), which is enclosed by the starting
marker (OMOVE and the end marker )OMOVE.
Example: Rinsing a sensor:
t/s Command Parameters Parameters
ДДДДД ДДДДДДДДДДДДД ДДДДДДДДДДДДДДДДДДДДДДДД ДДДДДДДДДДДДДДДДДДДДДДДД
(OMOVE
CHANGER Selection 1 Rack name
Lift rate 1 25 Lift rate 2 25
Shift rate 20 Beaker test mode single
Shift direction auto On beaker error MOVE_S
MOVE_B Special beaker waste to tower 1
LIFT on tower 1 to position rinse mm
PUMP Address 1.rinse State on
10 PUMP Address 1.aspir State on
PUMP Address 1.rinse State off
PUMP Address 1.aspir State off
LIFT on tower 1 to position shift mm
)OMOVE
...