Epiphan Networked VGA Grid - Manual (Page 205)

Networked VGA Grid User Guide 5-4 File and recording transfer
Table 28 FTP Automatic Upload Configuration Options
Name Description / Options
Server address The IP address (or fully qualified domain name) of the FTP server.
Server port The port used by the target FTP server. Standard port is 21.
Login Username for the FTP server.
Password Password for the FTP user.
Use temp file Causes files to be named with .part extension on the server during active upload. When the
upload completes, the file is renamed to the appropriate extension (.mov, .mp4 or .avi).
Configure AFU using RSync (part 2 of 3)
This procedure assumes you have completed the steps in Enable and configure the frequency of AFU (part 2 of
3) and wish to continue with configuration of upload using RSync.
To configure upload using RSync:
1. Select RSync Client from the protocol drop down list in the Automatic File Upload configuration page;
the lower half of the page reflects the selection.
2. Specify the target Server address. If your system is configured with DHCP or has a valid DNS
configuration (see Configure Network Settings ), you can use the server’s fully qualified domain name
instead of the IP address.
3. Specify the Server module. This is the name of the shared folder on the server. If needed, request this
value from your network administrator.
193