Epiphan Networked VGA Grid - Manual (Page 284)

Networked VGA Grid User Guide 7-11 Configuration Keys for Third Party APIs
Key Values Description
pll -999...999 Specifies PLL adjustment.
Changes the number of pixels in the line.
tune_interval 0...9999 Specifies the number of seconds between auto-adjustments.
To disable auto-adjustments, set to 0.
vshift -20...20 Specifies vertical shift.
For shifts up, use positive values.
For shifts down, use negative values.
Broadcast Configuration Keys
The following broadcast configuration settings are supported.
Table 47 Supported Broadcast Configuration Keys
Key Values Description
bcast_disabled on
empty string ("")
Enables or disables the broadcast.
To disable broadcast, set to on.
To enable broadcast, set to empty string ("").
rtsp_port 1000...65535,
but not 5557
Specifies the port for RTSP streaming. Note port 5557 is used for
network discovery and cannot be used for streaming.
streamport 1000...65535,
but not 5557
Specifies the port used for streaming. Note port 5557 is used for
network discovery and cannot be used for streaming.
Channel Encoder Configuration Keys
The following channel encoder configuration settings are supported. For more information on individual items
listed, see Create and configure channels .
Table 48 Supported Channel Encoder Configuration Keys
Key Values Description
autoframesize on
empty string ("")
Enables or disables use of the current signal’s resolution as the
frame size. Is switched to off if a frame size is manually specified.
To use current signal’s frame size, set to on.
To specify frame size directly, set to empty string ("").
272