Hypertherm Phoenix 8.0 - Manual (Page 148)

Library Shapes
141
BaseWidth
Enter the width of the base of the part.
Left Side Angle
Enter the number of degrees for the angle on the left side of the part.
Right Side Angle
Enter the number of degrees for the angle on the right side of the part.
Lead-In/Lead-Out Length
Enter the appropriate value to ensure proper piercing (lead-in) and gas bleed-off (lead-
out) to obtain optimum cut quality.
The location for the lead-in and lead-out is fixed, but can be changed by using the
ShapeWizard and then saving the new shape to disk.
Part Type
Indicate whether you want to cut the part as a separate piece or a hole in a larger part.
Chain cut options are available for simple shapes that have external cut paths.