Hypertherm Phoenix 8.0 - Manual (Page 473)

Program Codes
466
3)
Clamp and Unlock all carriages and G00 index inward on transverse (optional command -
may used to space all stations away from edge / OT switch of machine)
4) Lock and Unclamp all and G00 index to space first station (remember-first station has no
clamping/locking on board)
5) Unlock and Clamp next station and G00 index to space the next station.
6) Repeat Step 5 until as many stations as needed are spaced.
Note: Homing also automatically includes the commands necessary to push the stations to the
side and lock / clamp them whenever the transverse is homed, if Auto Torch Spacing is