Hypertherm Phoenix 8.0 - Manual (Page 360)

Password Setups
353
Stations 1-8 are designated for plasma; stations 9-20 are
designated for oxy fuel. Type V control.
X Home Switch
Indicates that the machine has traveled to its X axis home
position. If the X axis Use Home Limit Switch parameter is set
to YES and a homing function is performed, the X axis moves
in the specified home direction at the fast home speed until the
input is activated. The X axis then decelerates to a stop and
moves in the opposite direction at the slow home speed until
the switch is deactivated. After the switch is deactivated, the X
axis decelerates to a stop or, if the Use Marker Pulse parameter
is set to YES, continues until the encoder marker pulse is
detected.
Y Home Switch
Indicates that the machine has traveled to its Y axis home
position. If the Y axis Use Home Limit Switch parameter is set
to Yes and a homing function is performed, the Y axis moves
in the specified home direction at the fast home speed until the
input is activated. The Y axis then decelerates to a stop and
moves in the opposite direction at the slow home speed until
the switch is deactivated. After the switch is deactivated, the Y
axis decelerates to a stop or, if the Use Marker Pulse parameter
is set to Yes, continues until the encoder marker pulse is
detected.
Z Home Switch
Indicates that the machine has traveled to its Z axis home
position. If the Z axis Use Home Limit Switch parameter is set
to Yes and a homing function is performed, the Z axis moves
in the specified home direction at the fast home speed until the
input is activated. The Z axis then decelerates to a stop and
moves in the opposite direction at the slow home speed until
the switch is deactivated. After the switch is deactivated, the Z
axis decelerates to a stop or, if the Use Marker Pulse parameter
is set to Yes, continues until the encoder marker pulse is
detected.
Y Overtravel Switch
Indicates that the machine has traveled into its full positive
travel of a Y axis. If hardware overtravels are enabled and this
input is activated, the CNC stops all motion and generates a
fault message. Motion is not re-enabled until the switch is
deactivated.
X Overtravel Switch
Indicates that the machine has traveled into its full positive
travel of a X axis. If hardware overtravels are enabled and this
input is activated, the CNC stops all motion and generates a