Hypertherm Phoenix 8.0 - Manual (Page 330)

Diagnostics
323
This message displays if the control detects a negative limit switch in the Transverse axis.
This can also occur if the limit switch input is set for the wrong polarity or the limit
switch wiring is not properly connected.
If the Transverse axis tripped the negative limit switch, use Manual mode to jog the
Transverse axis away from the limit switch.
Rail Negative Hardware Overtravel Reached
This message displays if the control detects a negative limit switch in the Rail axis. This
can also occur if the limit switch input is set for the wrong polarity or the limit switch
wiring is not properly connected.
If the Rail axis tripped the negative limit switch, use Manual mode to jog the Rail axis
away from the limit switch.
Transverse Positive Software Overtravel Reached
This message displays if the Transverse axis position is greater than the Maximum Travel
Limit setup parameter for the Transverse axis.
If this occurs, use Manual mode to jog the Transverse axis to a position within the Travel
Limit setup parameters.
Rail Positive Software Overtravel Reached
This message displays if the Rail axis position is greater than the Maximum Travel Limit
setup parameter for the Rail axis.
If this occurs, use Manual mode to jog the Rail axis to a position within the Travel Limit
setup parameters.
Transverse Negative Software Overtravel Reached
This message displays if the Transverse axis position is less than the Minimum Travel
Limit setup parameter for the Transverse axis.
If this occurs, use Manual mode to jog the Transverse axis to a position within the Travel
Limit setup parameters.
Rail Negative Software Overtravel Reached
This message displays if the Rail axis position is less than the Minimum Travel Limit
setup parameter for the Rail axis.
If this occurs, use Manual mode to jog the Rail axis to a position within the Travel Limit
setup parameters.
Dual Gantry Skew Error Exceeded
This message displays when the control has detected a position error fault between the
two drive axes on the dual gantry. It also may appear if the position feedback loops are