Hypertherm Phoenix 8.0 - Manual (Page 421)

Sensor THC
414
Press the Timing Diagram soft key to view the timing diagram from setups.
Retract Delay
Specifies the delay between the cut off and the torch retract.
Auto Voltage Set
Samples the Arc Voltage that is generated when cutting at a specific cut height. The Arc
Voltage value relative to the manual cut height sample is used when cutting the part
instead of a predetermined Arc Voltage.
Set Arc Voltage
The Arc Voltage to use for the material being cut.
Cut Height
Selects the cut height from the plate. This sets the initial cut height before arc voltage
control is activated when the system is operating in automatic mode.
Pierce Height
Selects the pierce height. This can be entered as a percentage of the cut height or as an
actual distance.
Voltage Control