Hypertherm Phoenix 8.0 - Manual (Page 218)

Library Shapes
211
Base Width
Enter the width of the base of the part.
Side Height
Enter the height of the rectangular portion of the part.
Convex Diameter
Enter the diameter of the convex portion of the part.
Lead-In/Lead-Out Length
Enter the appropriate value to ensure proper piercing (lead-in) and gas bleed-off (lead-
out) to obtain optimum cut quality.
The location for the lead-in and lead-out is fixed, but can be changed by using the
ShapeWizard and then saving the new shape to disk.
Part Type
Indicate whether you want to cut the part as a separate piece or a hole in a larger part.
Chain cut options are available for simple shapes that have external cut paths.