Hypertherm Phoenix 8.0 - Manual (Page 576)

Voyager III
569
Sensor THC Interface
Analog 9C Divider J2
Pin # Description Pin #
5 24V Common 1
6 Nozzle Contact Sense 3
8 Nozzle Contact Enable 4
1 Analog In+ 6
2 Analog In– 7
Chassis Shield No Connection
Mating Connector
Connector: 9C D-Sub Amp # 205204-4 or equivalent
Backshell: Amp #748676-1 or equivalent
Pins: Amp #5-66506-9 ( 20-24 AWG ) or equivalent
Cable Belden #9505 or equivalent
Note: Wiring pattern continues for Analog 2-6
It is recommended that the Hold Ignition Input be wired to the Power Supply through an
external relay from the I/O connector. Please refer to instructions from supply
manufacturer for details on connection to the Hold Ignition Input.
Voltage Divider Card Pinout ( Series 3 )
Part # PBS-0061
Divider PCB - 2C Connector J1
Pin #
Description
1 85 -265 VAC Power Input ( 47-63Hz )
2 85 -265 VAC Neutral Input
Mating Connector
2C Phoenix Connector – Phoenix Part # 1840366
Divider PCB - 8C Connector J2 to Control Analog Connector
Pin # Description
1 +24 VDC Common
3 Nozzle Contact Sense
4 Nozzle Contact Enable
6 Analog Out +
7 Analog Out –
8 E Ground