Hypertherm Phoenix 8.0 - Manual (Page 460)

Program Codes
453
M17 Oxy Gas On
M18 Oxy Gas Off
M19 Cancel All Stations
M26 Station Select On
M27 Station Select Off
M28 CBH / Rotator(s) Disable
M29 CBH / Rotator(s) Enable
M30 End of Program (same as M02)
M31 Reset Functions (Cut Off, Marker Off, Kerf Off)
M32 Unclamp / Unlock All Stations
M32 Tvalue Unclamp / Unlock ‘T” Station, where T = 1 through 19
M33 Unclamp / Lock All Stations
M34 Clamp / Unlock All Stations
M34 Tvalue Clamp / Unlock ‘T” Station, where T = 1 through 19
M35 Clamp / Unlock All Stations Mirror
M35 Tvalue Clamp / Unlock Mirror “T” Station, where T = 1 through 19
M36 Tvalue Process Select “T” where T value selects the process
1 – Plasma 1
2 – Plasma 2
3 – Marker 1
4 – Marker 2
5 – Laser
M37 Tvalue (1-20) Select Station “T” where T = 1 through 20
M38 Tvalue (1-20) Deselect Station “T” where T = 1 through 20
M40 Start of Subroutine
M40 Xvalue Start of Subroutine. Executes the repeat X times
M41 End of Subroutine
M48 Speed Override Enable
M49 Speed Override Disable
M50 Height Sensor Disable
M51 Txx.xx Height Sensor Enable (Temporary Optional Time Delay in seconds
before Enable)
M52 Height Sensor Disable and Raise Torch
M53 Height Sensor Enable and Lower Torch
M63 User Defined 1 On
M64 User Defined 1 Off
M54 User Defined 2 On
M55 User Defined 2 Off
M56 User Defined 3 On
M57 User Defined 3 Off
M58 User Defined 4 Off
M59 User Defined 5 On
M65 End of Program (same as M02) or Auto Reload
M72 Marker Offset 2 Off
M73 Marker Offset 2 On
M75 A Axis/Tilt Go to Home Command - Rapid Index