Hypertherm Phoenix 8.0 - Manual (Page 298)

Pause
291
The differences between the On-path Pause Window and the Off-path Pause window are
outlined below.
Return to Path
Press the Return to Path soft key in the Off-path Pause window to return the cutting
device to the point on the cut path from which it was jogged away. This feature is useful
for inspecting or replacing components after cut loss and then returning to the cut loss
point. When the cutting device is back on the cut path, the On-path Pause Window is
restored and cutting can resume.
Move Part
Moves the entire part on the plate. The point along the cut path to which the cutting
device moves becomes the current position of the cutting device. The On-path Pause
window displays again because the cutting device is on path.
Off-Path Restart
Press the Start key from the Off-path Pause window, to construct a lead-in from the off-
path point back to the original part.
In a cut loss situation, the operator can use the Backup on Path key in the On-path Pause
window menu to position the cutting device on the cut path where the cut was lost. The