Hypertherm Phoenix 8.0 - Manual (Page 152)

Library Shapes
145
Base Width
Enter the width of the base of the part.
Height
Enter the height of the part.
Left Side Angle
Enter the number of degrees for the left side angle of the part.
Right Side Angle
Enter the number of degrees for the right side angle of the part.
Lead-In/Lead-Out Length
Enter the appropriate value to ensure proper piercing (lead-in) and gas bleed-off (lead-
out) to obtain optimum cut quality.
The location for the lead-in and lead-out is fixed, but can be changed by using the
ShapeWizard and then saving the new shape to disk.
Part Type
Indicate whether you want to cut the part as a separate piece or a hole in a larger part.
Chain cut options are available for simple shapes that have external cut paths.