Hypertherm Phoenix 8.0 - Manual (Page 51)

Setups
44
Oxy Fuel
The system supports configurations with both the Sensor OHC and other OHC lifters. In
such a mixed configuration, stations must be defined and using stations selects, auto/all
selects or manual selects. Although the system allows both types of OHC lifters, only
one type can be used at a time.
The CNC comes with the following built-in control logic for Oxy Fuel cutting. When
oxy fuel is selected, the following parameters are available to customize the logic for the
metal being cut. As these parameters are changed, the timing diagram below changes to
show the new timing parameters. This screen is located under the Cut Types soft key in
the Setups.
Note: Press the Start key twice to bypass all timers and begin the cut.