Hypertherm Phoenix 8.0 - Manual (Page 369)

Password Setups
362
Remote Air Plasma Used as part of the HD3070 automatic gas console
communications to signal the Air Plasma output.
Remote H35/ N2 Plasma
Used as part of the HD3070 automatic gas console
communications to signal the H35/N2 output.
Remote O2 Plasma
Used as part of the HD3070 automatic gas console
communications to signal the O2 Output.
Change Consumable
Activates when a consumable data value on the Change
Consumable Screen has reached its preset maximum.
Generally, this output is tied to an external indicator light
or audible alarm to prompt the system operator to change
the appropriate consumable. The affected consumable data
must be reset on the Change Consumable Screen to clear
the output.
Current Set BCD
Sets the current at the plasma power supply or marker
supply. These outputs are tied to the BCD inputs.
Combinations of the current values are used to attain the
desired current set point.
Marker Control
Activates the marker tool during the marking process.
Traditionally, the marker tool is activated through the
combination of Marker Enable and Cut Control outputs.
All the noted options are available and can be configured
on the Marker Setup screen for the desired process timing
and operational results.
Program Running
Active any time the CNC is operating within a part
program.
Station Enable 1-20
Activates any function specific to a torch station and are
controlled through M37T and M38T codes within a part
program. Typically, these codes generally enable a torch
station for use. Stations Usually, stations 1-8 are
configured with plasma and stations 9-20 are configured
with oxy fuel or other types of fuel. However, plasma can
only be configured on stations 1-8.
Station Lock 1-19
Are part of the Automated Torch Spacing feature. The
station lock locks the unused torch station to the gantry or
beam when the torch is not in use.