Hypertherm Phoenix 8.0 - Manual (Page 198)

Library Shapes
191
Elbow Outer Radius
Enter the radius of the outer edge of the part.
Elbow Inner Radius
Enter the radius of the inner edge of the part.
Elbow Angle
Enter the number of degrees of the angle formed by the straight edges of the part.
End Length
Enter the length of the ends of the part.
Lead-In/Lead-Out Length
Enter the appropriate value to ensure proper piercing (lead-in) and gas bleed-off (lead-
out) to obtain optimum cut quality.
The location for the lead-in and lead-out is fixed, but can be changed by using the
ShapeWizard and then saving the new shape to disk.
Part Type
Indicate whether you want to cut the part as a separate piece or a hole in a larger part.
Chain cut options are available for simple shapes that have external cut paths.