Hypertherm Phoenix 8.0 User Manual
Page 361
Password Setups
354
fault message. Motion is not re-enabled until the switch is
deactivated.
Limit Switch
Indicates that the machine has traveled into its full positive
travel of an axis. If hardware over travels are enabled and this
input is activated, the CNC stops all motion and generates a
fault message. Motion is not re-enabled until the switch is
deactivated. (Type “M” configuration only)
Ready to Fire PS 1-4
Ensures that all HD4070 power supplies have completed each
individual Initial Height Sense and are ready for use. The torch
ignition is held off by the Hold Ignition Input to the power
supply from the control. This input is exclusive to the HD4070
multiple power supply configuration.
Raise /Lower 4070 1-2
Used as a manual raise/lower command to the selected
HD4070 integrated THC through the CNC serial power supply
communication link. This input is exclusive to the HD4070
multiple power supply configuration.
X +Overtravel Switch
Indicates that the machine has traveled to its full positive travel
on the X axis. If hardware over travels are enabled and this
input is activated, the CNC stops all motion, generates a fault
message and only allows manual motion in the X axis negative
direction.
X –Overtravel Switch
Indicates that the machine has traveled to its full negative
travel on the X axis. If hardware overtravels are enabled and
this input is activated, the CNC stops all motion, generates a
fault message and only allows manual motion in the X axis
positive direction.
Y +Overtravel Switch
Indicates that the machine has traveled to its full positive travel
on the Y axis. If hardware overtravels are enabled and this
input is activated, the CNC stops all motion, generates a fault
message and only allows manual motion in the Y axis negative
direction.
Y –Overtravel Switch
Indicates that the machine has traveled to its full negative
travel on the Y axis. If hardware overtravels are enabled and
this input is activated, the CNC stops all motion, generates a
fault message and only allows manual motion in the Y axis
positive direction.