Hypertherm Phoenix 8.0 - Manual (Page 226)

Library Shapes
219
Base Width
Enter the width of the base of the part.
Top Width
Enter the width of the top of the part.
Overall Height
Enter the height of the part from the base to the top.
Side Height
Enter the height of the right side of the part. The height of the side must be less than the
overall height of the part.
Clearance Radius
Enter the length of the radius of the clearance curve.
Lead-In/Lead-Out Length
Enter the appropriate value to ensure proper piercing (lead-in) and gas bleed-off (lead-
out) to obtain optimum cut quality.
The location for the lead-in and lead-out is fixed, but can be changed by using the
ShapeWizard and then saving the new shape to disk.
Part Type
Indicate whether you want to cut the part as a separate piece or a hole in a larger part.
Chain cut options are available for simple shapes that have external cut paths.