Hypertherm Phoenix 8.0 - Manual (Page 282)

Part Options
275
Nested Repeat
Pattern Offsets
This is an automated feature that calculates the minimum spacing required between
repeated parts. The spacing is based on the size of the part (including lead-in and lead-
out), the kerf value and scrap clearance. This calculated spacing is not always optimum
but allows the part to be repeated without overlapping.
You can use this pre-calculated value or select new values manually. If you enter new
pattern offset values, the control automatically draws the new group pattern with the new
values.
Nest Distance
This is an automated feature that calculates the minimum spacing required between
nested parts. The spacing is based on the size of the part (including lead-in and lead-out),
the kerf value and scrap clearance. This calculated spacing is not always optimum but
allows the part to be repeated without overlapping.
You can choose to use this pre-calculated value or select new values manually. As you
enter new offset values, the control automatically draws the new nested pattern with the
new values.
Tip: If you change Nest Distance values manually, start with a simple nest (1 column x 1
row) and perform adjustments based on the display. As the nest distance values are
adjusted, the pattern displayed on screen is updated. When the Nest Distance is what you
want, increase the nest size to a 2-column, 2-row nest. Then the X and Y pattern offsets
can be adjusted in the same fashion. When the desired nest spacing has been reached,
increase the nest size as needed to the maximum size that the plate allows.