Hypertherm Phoenix 8.0 - Manual (Page 220)

Library Shapes
213
Base Width
Enter the width of the base of the part.
Center Height
Enter the height of the part between the base and the lowest point of the concave side.
Concave Diameter
Enter the diameter of the concave portion of the part.
Lead-In/Lead-Out Length
Enter the appropriate value to ensure proper piercing (lead-in) and gas bleed-off (lead-
out) to obtain optimum cut quality.
The location for the lead-in and lead-out is fixed, but can be changed by using the
ShapeWizard and then saving the new shape to disk.
Part Type
Indicate whether you want to cut the part as a separate piece or a hole in a larger part.
Chain cut options are available for simple shapes that have external cut paths.