Hypertherm Phoenix 8.0 - Manual (Page 458)

451
0B
Program Codes
1B
EIA RS-274D
The control supports EIA RS-274D part programs. An EIA RS-274D program lists the
sequence of lines, arcs, speeds, kerf and I/O functions that are used to create a part. While the
user is free to program in EIA using the standard text editor, it is recommended that the
ShapeWizard

Graphical Programming environment be used instead.
Following is a list of the EIA codes that are directly supported, mapped, or currently
unsupported by the control. Mapped EIA codes are automatically converted upon program load
into directly supported EIA codes. Unsupported EIA codes are ignored. All other EIA codes
generate an error.
10B
Directly Supported EIA Codes
EIA CODE DESCRIPTION
Fvalue Machine Speed (if Speed Override enabled)
Nvalue Line Number
(text) Comments
Xvalue X Axis Endpoint or other Data
Yvalue Y Axis Endpoint or other Data
Ivalue I Axis Integrand or Part Option Data
Jvalue J Axis Integrand or Part Option Data
Ovalue Svalue Output (1-64), State (0-Off or 1-On)
Wvalue Svalue Wait for Input (1-64), State (0-Off or 1-On)
G00
Rapid Traverse Linear Interpolation
G00 Avalue Sets Tilt angle – A is the angle value in degrees
G00 XYval Aval Performs Linear Interpolation of Tilt angle along line segment.
G01 Avalue Fvalue Sets Tilt angle value in degrees with a speed command in RPM
G00 Xn Yn Traverse command where n = value to move the desired axes a distance.
G00 Zx.xx Tx Index Sensor™ THC height “Z” distance for torch “T”. Manual mode
only.
G00 Cxx Move to rotate “C” position
G01 Cxx Fxx Move to rotate “C” position with Speed “F” command in RPM
G00 C180- Rotate Axis offset 180 degrees will continue to rotate in the proper
direction
G00 C-180- Rotate Axis offset -180 degrees will continue to rotate in the proper
direction
G01 C180- Fxx
Rotate Axis offset 180 degrees with speed
G01 C-180- Fxx Rotate Axis offset -180 degrees with speed
G01 Linear Interpolation (at Cut Speed)
G02 Clockwise Circular Interpolation
G03 Counterclockwise Circular Interpolation
G04 Preset Dwell (uses Setup Dwell Time)
G04 Xvalue Program Dwell in Seconds